Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re[2]: Plastic moment capacity of concrete filled steel pipe

[Subject Prev][Subject Next][Thread Prev][Thread Next]
     Anand,

     See section I2-2 of the LRFD Manual of Steel Construction (this is for
     the edition which is silver colored).  Essentially, a modified yield
     stress and modulus are calculated.  These are then used to determine
     the ultimate compression and bending strength, which are then used in
     an interaction equation.

     John Hubert


______________________________ Reply Separator _________________________________
Subject: Re:Plastic moment capacity of concrete filled steel pipes
Author:  AnandNene(--nospam--at)aol.com at Internet
Date:    3/12/98 7:24


I would like to know a reliable reference to estimate plastic moment capacity
of concrete filled steel pipe and detailing requirements.

I am reviewing a sope stabilization design where 8" dia. steel pipes
(Fy=50ksi) filled with f'c=5000 psi concrete are proposed.  There is no
reinforcing inside the pipe nor any provision for shear transfer.  The
designer used capacity of both cocnrete and steel to estimate total plastic
moment capacity claiming that for small diameter pipes this is the way things
are done - on Caltrans projects.  I do not do work for Caltrans and not too
familiar with bridge projects.

I would appreciate comments and references on this subject.

Thanks!

Anand Nene, S. E.