Need a book? Engineering books recommendations...
Re: Handicap Wood Ramp Detail[Subject Prev][Subject Next][Thread Prev][Thread Next]
- To: seaint(--nospam--at)seaint.org
- Subject: Re: Handicap Wood Ramp Detail
- From: "K. Hemmatyar" <engineer(--nospam--at)infinet.net>
- Date: Thu, 24 Sep 1998 09:46:13 -0700 (PDT)
I was doing a similar handicapped ramp few months ago but it was concrete. However it is common to have the end of the ramp made out of concrete in order to facilitate the transition of the sloped (generally pressure treated wood) to the flat part. Regards K. Hemmatyar ______________________________________________________ At 01:39 PM 9/24/98 GMT, you wrote: >I am working on a handicap ramp made of wood. It has to have a maximum slope >of 1:12 for ADA. The question I have is how to detail the bottom of the ramp >where it meets the ground. Since the ramp has such a slight slope, the >stringers die into the ground. Let me illustrate. If I have a 2x8 side >stringer sloping down supporting the edge of deck it will be in contact (or >have a taper cut) for 7 to 8 feet at the bottom of the ramp. > >How are wood ramps usually detailed at the base of the ramp to provide >support, but I assume, no contact with the ground? Is a long slab of >concrete poured under it? > > >Richard Lewis, P.E. >Missionary TECH Team >rlewis(--nospam--at)techteam.org > >The service mission like-minded Christian organizations >may turn to for technical assistance and know-how.
- Prev by Subject: Handicap Wood Ramp Detail
- Next by Subject: RE: Handicap Wood Ramp Detail
- Previous by thread: Re: Handicap Wood Ramp Detail
- Next by thread: RE: Handicap Wood Ramp Detail