Need a book? Engineering books recommendations...
RE: waterstop2[Subject Prev][Subject Next][Thread Prev][Thread Next]
- To: "'seaint(--nospam--at)seaint.org'" <seaint(--nospam--at)seaint.org>
- Subject: RE: waterstop2
- From: "Horning, Dick/CVO" <dhorning(--nospam--at)CH2M.com>
- Date: Wed, 30 Sep 1998 09:20:02 -0600
Be aware the inside radius of a #11 bend is 6", and the standard 90 degree tail is 2'-0" out-to-out. -----Original Message----- From: KH H [SMTP:hongkik(--nospam--at)hotmail.com] Sent: Wednesday, September 30, 1998 5:15 AM To: seaint(--nospam--at)seaint.org Subject: Re: waterstop2 >From: "¹ÚÃ¢¹ü" <cbpark(--nospam--at)ns.kopec.co.kr> >To: <seaint(--nospam--at)seaint.org> >Subject: waterstop2 >Date: Wed, 30 Sep 1998 10:44:28 +0900 >Reply-To:seaint(--nospam--at)seaint.org > Perhaps this is one of the solution to the waterstop connecting between 2 walls. Since the shear wall is very thick and the main bars are vertical in direction, the outside #11 horizontal bars can bend into 90 deg cog (L shape) to allow the water stop to pass through. Add short horz bars with suffient bond length to transfer loads from one panel to the other across the water stop. The only problem is when the opposite wall is relatively thin to allow the inner layer of horz. bars.
- Prev by Subject: RE: waterstop2
- Next by Subject: WELCOME
- Previous by thread: RE: waterstop2
- Next by thread: Mag 7.3 (+) Saratoga Earthquake