Need a book? Engineering books recommendations...
RE:Galvanic corrosion[Subject Prev][Subject Next][Thread Prev][Thread Next]
- To: seaint(--nospam--at)seaint.org
- Subject: RE:Galvanic corrosion
- From: Bernardo Horowitz <horowitz(--nospam--at)NPD.UFPE.BR>
- Date: Wed, 05 Nov 1997 14:55:00 -0200
Here in Brazil rolled shapes are available in A36 steel only. For all other
steels only plates are available.
From: "Horning, Dick/CVO" <dhorning(--nospam--at)CH2M.com>
To: "'seaint(--nospam--at)seaint.org'" <seaint(--nospam--at)seaint.org>
Subject: RE: galvanic corrosion
No, they are both carbon steels. But I have to ask, if you're using A588
for corrosion resistance, why not use it for the diagonals too? If for
higher strength, why not use A572 or a dual-certified steel?
From: Bernardo Horowitz [SMTP:horowitz(--nospam--at)NPD.UFPE.BR]
Sent: Tuesday, November 04, 1997 8:25 AM
Subject: galvanic corrosion
Does anybody anticipate galvanic corrosion problems if one welds
A36 diagonals to A588 chords?
Bernardo Horowitz, CE
- Prev by Subject: RE: galvanic corrosion
- Next by Subject: Re: Garage Floor Design
- Previous by thread: RE: galvanic corrosion
- Next by thread: ringwall reinforcing design