Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

RE: tap holes

[Subject Prev][Subject Next][Thread Prev][Thread Next]
I hope it's better than their "O" Ring Design Manual  :<)

Bill Cain, SE
Oakland, CA


	-----Original Message-----
	From:	Harold Sprague [SMTP:harold.sprague(--nospam--at)neenan.com]
	Sent:	Friday, February 26, 1999 6:55 AM
	To:	'seaint(--nospam--at)seaint.org'
	Subject:	RE: tap holes

	My favorite resource is the Fastener Design Manual by NASA.  A
good practice
	in fasteners is to design to develop the strength of the bolt
wherever
	possible.

	Harold Sprague


	-----Original Message-----
	From: Matt Jordan [mailto:MattJ(--nospam--at)crjarch.com]
	Sent: Wednesday, February 24, 1999 6:58 PM
	To: 'seaint(--nospam--at)seaint.org'
	Subject: RE: tap holes


	Greetings,
	A quick question, I'm trying to find bolt values for if I tap
into A36
	plate and thread in bolts. AISC tables are for bolts with
hardened nuts,
	do same values apply if its a tapped plate?
	Regards, matt jordan