Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

RE: Flare Groove Weld

[Subject Prev][Subject Next][Thread Prev][Thread Next]
Will BTC-P10 cover flare bevels as well as flare V's?

> -----Original Message-----
> From:	BILL PULYER [SMTP:WPULYER(--nospam--at)steelfab-inc.com]
> Sent:	Wednesday, November 03, 1999 11:51 AM
> To:	'seaint(--nospam--at)seaint.org'
> Subject:	RE: Flare Groove Weld
> 
> There is a prequalifed flare-bevel groove welded joint.  It is the partial
> penetration joint shown in AWS D1.1 as BTC-P10 or BTC-P10-GF (page 65).
> 
> Bill Pulyer
> 
> > -----Original Message-----
> > From:	Balmer, James A [SMTP:james.a.balmer(--nospam--at)lmco.com]
> > Sent:	Wednesday, November 03, 1999 11:42 AM
> > To:	'seaint(--nospam--at)seaint.org'
> > Subject:	Flare Groove Weld
> > 
> > AWS D1.1 Table 2.1 lists the effective weld size of a flare V groove
> weld
> > as
> > 1/2 the outside radius.  Because AWS lists an effective weld size in the
> > table, I feel certain that an extensive amount of testing was performed
> to
> > back this formula up.  If this is the case, why not have a prequalified
> > flare V joint?
> > 
> > James Balmer  
> > 
>