From: "Sprague, Harold O." <SpragueHO(--nospam--at)bv.com>
Date: Wed, 8 Mar 2000 09:12:48 -0600
Check out http://www.mcmaster.com/. For the various types of threading
available (coil, coarse, fine, Acme, etc.), and the pitch. Check out ANSI
ANSI B1.1 for the dimensions. If the thread is standard coarse, and you
know the pitch, use the formulas in the AISC 9th Ed., p 4-147.
> -----Original Message-----
> From: Barry H. Welliver [SMTP:wellive(--nospam--at)attglobal.net]
> Sent: Tuesday, March 07, 2000 6:32 PM
> To: seaint(--nospam--at)seaint.org
> Subject: Threaded Rod Data
> Where can I find information about threaded rods less than 1/4"
> diameter? Specifically, root diameter or net section etc.
> Barry H. Welliver