From: "Barry H. Welliver" <wellive(--nospam--at)attglobal.net>
Date: Wed, 08 Mar 2000 09:34:18 -0700
That is one great resource. (McMaster)
I had forgotten about the AISC formula.
Barry H. Welliver
"Sprague, Harold O." wrote:
> Check out http://www.mcmaster.com/. For the various types of threading
> available (coil, coarse, fine, Acme, etc.), and the pitch. Check out ANSI
> ANSI B1.1 for the dimensions. If the thread is standard coarse, and you
> know the pitch, use the formulas in the AISC 9th Ed., p 4-147.
> Harold Sprague
> > -----Original Message-----
> > From: Barry H. Welliver [SMTP:wellive(--nospam--at)attglobal.net]
> > Sent: Tuesday, March 07, 2000 6:32 PM
> > To: seaint(--nospam--at)seaint.org
> > Subject: Threaded Rod Data
> > Where can I find information about threaded rods less than 1/4"
> > diameter? Specifically, root diameter or net section etc.
> > Barry H. Welliver