Return to index: [Subject] [Thread] [Date] [Author]

RE: base plate software

[Subject Prev][Subject Next][Thread Prev][Thread Next]
Don't forget the preheating requirements before welding to the column and
possible especial milling needs.

Ghassem.

-----Original Message-----
From: ad026(--nospam--at)hwcn.org [mailto:ad026(--nospam--at)hwcn.org]
Sent: Wednesday, June 14, 2000 6:23 PM
To: seaint(--nospam--at)seaint.org
Subject: Re: base plate software


> From: Panos Trochalakis <panost(--nospam--at)ckcps.com>

> Could either a steel fabricator or someone from AISC respond regarding
> economical base plate thicknesses? At what point does it become more
> economical to start using stiff. plates or other stiffening elements to
> reduce the base plate thickness. An example is using stiff. plates or
small
> channels at moment frame or braced frame columns with large uplift loads.
> There would be a savings in material. However, there is added shop welding
> of the stiffening elements.

It takes a lot of steel to balance the labour cost for even small
amounts of welding and material handling to make stiffeners.

However, above about 1 1/2" thick base plates you will have difficulty
getting holes punched. Then the cost of reaming holes probably matches
labour for welding a couple simple stiffeners.

After that, base plate thickness probably isn't a major factor in more
complex base arrangements.

-- 
Paul Ransom, P. Eng.
Civil/Structural/Project/International
Burlington, Ontario, Canada
<mailto:ad026(--nospam--at)hwcn.org> <http://www.hwcn.org/~ad026/civil.html>