Return to index: [Subject] [Thread] [Date] [Author]

Retaining Wall

[Subject Prev][Subject Next][Thread Prev][Thread Next]
I have designed a 350ft masonry retaining wall adjacent to a property line
near the top of a hill. The plan checker scribbled on a piece of paper and
gave it to my client at the plan check counter. 

No structural comments.

Grading Comments: 
Calculate Qmax + Safety factor and size the V-ditch at the top of the wall
for this value.

This seems silly to me. The V-ditch at the top of the retained soil in my
drawing is at least 6" wide and is 6" below the top of the wall. The
backfill slopes 2:1 for about 7 feet back to the property line. This the
hill slopes at about 4:1 after the property line and probably peaks about 6
feet above the top of soil @ the property line.

I have long forgotten my water resources engineering coursework but in the
books I have looked into, in order to calculate Q, I need to know the area
(in acres) draining to the wall. Since the area that is draining is not on
the property, the owner has no survey or map that allows me to figure this
area out. I have followed all of the requirements of the soils report
(Including designing the wall for 70pcf (More than water ??? Come on !))

My questions are:
1.Is this really necessary? The client is improving the situation and the
wall has drain rock, perforated pipe, and the v-ditch at the top. I don't
want to relearn this stuff and still be unsure of what I am doing.

2. If I do calculate Q, I assume that I divide Q by the width of my ditch
and the velocity or the runoff along the ditch to figure out how deep the
water gets in the ditch so it doesn't spill over the front of the wall.
Also, what is a reasonable V to assume, I was thinking 3-5 ft/sec.

3. Is this really necessary???

Any advice is welcomed.
-Gerard


******* ****** ******* ******** ******* ******* ******* *** 
*   Read list FAQ at: http://www.seaint.org/list_FAQ.asp 
*   This email was sent to you via Structural Engineers 
*   Association of Southern California (SEAOSC) server. To 
*   subscribe (no fee) to the list, send email to 
*   admin(--nospam--at)seaint.org and in the body of the message type 
*   "join seaint" (no quotes). To Unsubscribe, send email 
*   to admin(--nospam--at)seaint.org and in the body of the message 
*   type "leave seaint" (no quotes). For questions, send 
*   email to seaint-ad(--nospam--at)seaint.org. Remember, any email you 
*   send to the list is public domain and may be re-posted 
*   without your permission. Make sure you visit our web 
*   site at: http://www.seaint.org 
******* ****** ****** ****** ******* ****** ****** ********