Return to index: [Subject] [Thread] [Date] [Author]

Concrete Problem

[Subject Prev][Subject Next][Thread Prev][Thread Next]
I would appreciate anyone who can give me some help on this one:
 
How does one go about hardening and strengthening a layer of concrete that has already been cast and cured, without removing the concrete entirely?  In other words, is there a product that can be added to the surface of the concrete to harden it?
 
The concrete in this particular case would be difficult to remove because of embedded piping.  The hardened surface would then have tile set on it, and would form the floor of a hot water wading pool.  The layer of concrete which needs to be hardened was poured over 2 months ago, and is quite sandy in color with hardly any hint of gray.  This would seem to me to indicate a low cement content.
 
Anybody have any ideas on this one?
 
 
 
T. Eric R. Gillham PE
PO Box 3207 Agana Guam 96932
Ph:   (671) 477-9224
Fax: (671) 477-3456
Cel  (671) 687-7115
 
teric(--nospam--at)gk2guam.com