Return to index: [Subject] [Thread] [Date] [Author]

Re: Lubrication for Sliding Connection

[Subject Prev][Subject Next][Thread Prev][Thread Next]
But it is susceptible to chemical attack from petroleum products.

			Regards

			H. D. Richardson.

Roger Davis wrote:
> 
> When I want a "cheap" sliding connection, I use two layers of 6 mil poly.
> It will never get messy and it can be exposed to conditions that would
> deteriorate a lubricant.
> 
> Roger C. Davis
> Architect
> SDS Architects, Inc.
> 
> -----Original Message-----
> From:   John MacLean [mailto:john_maclean(--nospam--at)pomeroy.bc.ca]
> Sent:   Wednesday, March 07, 2001 7:44 PM
> To:     seaint(--nospam--at)seaint.org
> Subject:        Lubrication for Sliding Connection
> 
> Does anybody have a recommendation for lubricating a sliding connection for
> a building expansion joint? It's basically an HSS beam sitting on a
> stiffened seat with two threaded studs to the u/s of the HSS tightened
> finger tight through slotted holes in the seat. I'm looking for a grease to
> specify on the top of the seat that will provide a bit of lubrication,
> prevent corrosion on the bearing surface, last a long time and not drip onto
> the ceiling below. The connection will be inside a building  in Northern
> B.C. and should be heated year round.
> 
> Thanks,
> John MacLean
> 
>