Return to index: [Subject] [Thread] [Date] [Author]

RE: Seismic Design: Fresno CA

[Subject Prev][Subject Next][Thread Prev][Thread Next]
Blank areas on the seismic maps show locations of "Zone 3", since the
near-source factors are not required there for determination of seismic
coefficients. The City of Fresno is Zone 3, though some of Fresno County is
Zone 4.


Regards,
Dave K. Adams, S.E.
Lane Engineers, Inc.
PH: (559) 688-5263
E-mail: davea(--nospam--at)laneengineers.com


-----Original Message-----
From: Todd Hill [mailto:thill(--nospam--at)tkarch.com]
Sent: Monday, March 26, 2001 8:31 AM
To: 'seaint(--nospam--at)seaint.org'
Subject: RE: Seismic Design: Fresno CA


I did a post office there a few years back, but can't remember what zone I
used.
The city building department will tell you what zone to design for.
 

-----Original Message-----
From: Lao, Larry [mailto:LaoL(--nospam--at)vmcmail.com]
Sent: Monday, March 26, 2001 10:08 AM
To: 'seaint(--nospam--at)seaint.org'
Subject: Seismic Design: Fresno CA



	Dear fellow engineers, 

	Has anyone done any structural work in Fresno area recently? What
seismic zone, fault lines do they have? 

	Somehow there is a big blank area on the California's Maps of Known
Active Fault and Near-Source Zones. I almost think that there must be a
reason the ICBO leaves it uncovered, and I hope it was not due to economic
restrains. Can anyone enlighten me?

	I posted questions on SAFE vs. STADD few months ago, and got most
favorite replies for SAFE. We went ahead purchased SAFE, it's been working
fine. Thanks for all the input.

	Larry Lao