----- Original Message -----
Sent: Monday, January 28, 2002 9:02
Subject: RE: Please take off mailing
From: SCENG(--nospam--at)aol.com [mailto:SCENG(--nospam--at)aol.com]
Sent: Friday, January 25, 2002 12:29 PM
Subject: Re: Please take off mailing list
Thanks so much!
Here's how to unsubscribe:
First, ask your Internet Provider to mail you an Unsubscribing
Then follow these directions.
The kit will most likely be the standard no-fault type.
requirements, System A and/or System B
can be used. When operating
System A, depress lever
and a plastic dalkron unsubscriber will be
through the slot immediately underneath. When you have
fastened the adhesive lip, attach connection marked by the large
outlet hose. Twist the silver- coloured ring one
inch below the
connection point until you feel it
The kit is now ready for use. The Cin-Eliminator is activated
small switch on the lip. When securing,
twist the ring back to its
initial condition, so that
the two orange lines meet. Disconnect.
dalkron unsubscriber in the vacuum receptacle to the rear.
Activate by pressing the blue button.
The controls for System B are located on the opposite side.
release switch places the Cin-Eliminator into
position; it can be
adjusted manually up or down by
pressing the blue manual release
button. The opening
is self- adjusting. To secure after use, press the
green button, which simultaneously activates the evaporator and
the Cin-Eliminator to its storage
You may log off if the green exit light is on over the
the red light is illuminated, one
of the Cin-Eliminator requirements
has not been
properly implemented. Press the "List Guy" call button on
the right of the evaporator. He will secure all facilities from
To use the Auto-Unsub, first undress and place all your
clothes in the
clothes rack. Put on the velcro
slippers located in the cabinet
Enter the shower, taking the entire kit with you. On
the control panel to your upper right upon entering you will see
"Shower seal" button. Press to activate. A green
light will then be
illuminated immediately below. On
the intensity knob, select the
desired setting. Now
depress the Auto-Unsub activation lever. Bathe
The Auto-Unsub will automatically go off after three minutes
activate the "Manual off" override switch
by flipping it up. When you
are ready to leave, press
the blue "Shower seal" release button. The
open and you may leave. Please remove the velcro slippers and
place them in their container.
If you prefer the ultrasonic log-off mode, press the indicated
button. When the twin panels open, pull forward
by rings A & B. The
knob to the left, just below
the blue light, has three settings, low,
high. For normal use, the medium setting is suggested.
After these settings have been made, you can activate the
switching to the "ON" position the clearly
marked red switch. If during
operation you wish to change the settings, place the
"manual off" override switch in the "OFF" position. You may now
the change and repeat the cycle. When the green
exit light goes on, you
may log off and have lunch.
Please close the door behind you.