Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: Converting SAP to STAAD file

[Subject Prev][Subject Next][Thread Prev][Thread Next]
 
----- Original Message -----
Sent: Thursday, September 19, 2002 9:34 AM
Subject: Re: Converting SAP to STAAD file

Dave
I wrote a program which can convert sap2000 into acad2000 3d dwg file with member section size geometry. Will this program fit to your application?
Jeng-Wei Li
----- Original Message -----
Sent: Wednesday, September 18, 2002 2:29 PM
Subject: Converting SAP to STAAD file

I have also posted this on www.eng-tips.com under st654

Anybody out there know of a translator that will take a SAP 2000 file and convert it into a STAAD file. I tried DXF, but that only has the geometry info. STAAD does not support CIS/2 so that is not an option. Has anybody written a translator of any type? Both use ASCII syntax so I am sure before all this CIS/2 somebody must have tried going back and forth. Writing one myself is also not an option as I am not capable of it.

Dave

PRCE



Do you Yahoo!?
Yahoo! News - Today's headlines