Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: Spreadsheet on WEB to calculate S, I etc.

[Subject Prev][Subject Next][Thread Prev][Thread Next]
Thank you all for the reply.  I ended up using spreadsheet on  www.yakpol.net to get S, I etc for a fabricated beam.
 
Tahir
 
 
 
 
----- Original Message -----From: Ken Peoples
Sent: Sunday, October 27, 2002 11:12 AM
Subject: Re: Spreadsheet on WEB to calculate S, I etc.

If you have AutoCad, you can also use the "massproperties" command to do this.  Just make sure that you have your centroid to 0,0
 
Kenneth S. Peoples, P. E.
Lehigh Valley Technical Associates
1584 Weaversville Road
Northampton, PA 18067-9039
Phone: (610) 262-6345
Fax: (610) 262-8188
e-mail: kpeoples(--nospam--at)lvta.net
----- Original Message -----
Sent: Saturday, October 26, 2002 9:12 AM
Subject: Spreadsheet on WEB to calculate S, I etc.

Hello There Engineers:
 
Is there any spreadsheet / software available to calculate S, I etc. for a home made steel beam (made from steel plates) on WEB?
 
Thanks in advance for the help.
 
REGARDS,
 
Tahir