Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Liquefaction and Slabs-on-grade

[Subject Prev][Subject Next][Thread Prev][Thread Next]
I wonder if geopiers might be a viable solution to support the slab; possibly the installation process would relieve a significant portion of the liquifaction settlement potential.  I have no experience with them, but as I recall the advocates say its appropriate to view the geopiers as reinforcement of the soil as opposed to isolated individual supports.  And its possible, too, that the chemical nature of the insitu soils might be favorably altered by introduction of the limestone.  Something to talk about . . . I'm no soils expert, just a structural engineer.  JPRiley
I need a sanity check on a method I'm proposing to use for the foundations of a new building I'm designing.  The building will be located in Charleston SC.  The geotech report indicates that the site may settle "2-inches or less and be relatively uniform in nature" due to liquefaction.  Furthermore, the building could settle up to 3-inches due to the weight of fill needed to raise the building pads.
The report recommended 2 options for foundations.  The first would be to surcharge the site.  This would alleviate the 3-inches of dead load settlement due to the fill, but would still allow 2-inches of settlement due to liquefaction.  The second option would be to support the building on pile foundations which would eliminate both the dead load settlement and the liquefaction settlement. 
The method I've proposed to use is a combination of these 2 options.  The main structure (i.e. columns, walls, etc.) will be supported on pile foundations.  However, I'm proposing that the building pads be surcharged anyway so the floor slab can be supported on grade instead of piles. 
My reasoning is twofold.  First, even with the extra cost of the surcharge, I think a grade supported slab has got to be cheaper than a pile supported one.  Secondly, even if it does settle 2-inches in a large earthquake, it wouldn't pose a life safety issue.  Some repairs might have to be made to the slab after a large earthquake, but it won't be the only thing needing repair.  The new building is going right next to another soon-to-be-constructed building (separated by an isolation joint) which also has a grade supported slab.
Anybody see anything wrong (i.e. code violation, non-standard, etc.) with allowing the slab to settle during a large earthquake?
Any and all comments are welcome, especially from some of you west coast seismic guru's out there.
Thanks for the help.
Tripp Howard, P.E.

Do you Yahoo!?
New Yahoo! Photos - easier uploading and sharing