Need a book? Engineering books recommendations...
Fw: Mass concrete II[Subject Prev][Subject Next][Thread Prev][Thread Next]
- To: seaint(--nospam--at)seaint.org
- Subject: Fw: Mass concrete II
- From: THunt(--nospam--at)absconsulting.com
- Date: Wed, 4 Aug 2004 13:21:01 -0700
I just ran across another specification definition that reads any element with a least dimension of 3 feet and a total volume exceeding 8 cubic yards.
Thomas Hunt, S.E.
----- Forwarded by Tom Hunt/Americas/ABS on 08/04/2004 01:16 PM -----
08/04/2004 01:14 PM
I use to have a file on mass concrete as we had to study this for a particular client. I can't find my file but from memory ACI in an older document (late 1970s early 1980s?) actually had a definition of mass concrete as any element with a least dimension greater than 3 feet. This was removed and now there is some hazy words about mass concrete being any size where being massive can be a problem or some similar circular logic. I have also seen definitions that read any element with a least dimension of 3 feet and a volume to exposed surface area ratio greater than 2.5. This was to provide an exception for long strip footings.
As a side note, if you are concerned about massive concrete then it makes good sense to put a definition in your specification or general notes. Otherwise the contractor will just ignore it.
Thomas Hunt, S.E.
|"Yi Yang" <YI(--nospam--at)summit-sr.com>
08/03/2004 03:15 PM
I have a concrete pad, approximate 3' to 3'-6" thick, 26' wide, 100' long. Is this considered a "mass concrete"? ACI 207 talked about the cooling of mass concrete etc. Most of the ACI mass concrete reports are related to dam construction. Is this pad "massive" enough to cause any serious heat problem?
Thanks for any input.
Y i Y a n g, P. E.
SUMMIT ENGINEERING INC.
Santa Rosa, California
- Prev by Subject: Re: Mass concrete
- Next by Subject: MathCad Civil Programs
- Previous by thread: Re: Book on Structural Steelwork Connections
- Next by thread: retaining all vehicle surcharge