Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

RE: Exotic Wood Question

[Subject Prev][Subject Next][Thread Prev][Thread Next]
Title: Message
Check out Chapter 4 of the Wood Handbook, which list strength properties of various wood species.  If I recall correctly, these properties are based on clear wood specimens, and values are based on ultimate loads (i.e. unreduced for design purposes).
Hope this helps,

Thomas D. Skaggs, Ph.D., P.E.
Senior Engineer
APA - The Engineered Wood Association
7011 S. 19th Street
Tacoma, WA 98466
ph: 253/565-6600
fx: 253/620-7235

From: Caldwell, Stan [mailto:scaldwell(--nospam--at)]
Sent: Wednesday, December 29, 2004 08:36
To: SEAINT Listserv
Subject: Exotic Wood Question
Importance: Low

I am writing on behalf of my nephew, Jake, who is in the eighth grade.  He is participating in a science olympiad and needs to fabricate a laminated wood beam and load test it.  According to Jake, the beam must span 350 mm (13.78") and be no higher than 40 mm (1.57") and no wider than 20 mm (0.79").  It must be a straight, solid rectangular section fabricated from strips of wood no thicker than 3.175 mm (0.125"), glue, and nothing else.  Finally, it must support a center load of 15 Kg (33.1#) with a deflection less than 20 mm (0.79").
I am thinking that the winning beam will be fabricated from wood that is dense and very fine-grained, without knots or other irregularities.  In other words, an exotic hardwood from South America or Asia, like Pau Lope or Teak, rather than good old Southern Pine or Douglas Fir.  The wood must be available in Dallas, or available online with delivery within the next two weeks.  Of course, such woods do not appear in NDS, so I have very limited information on them.  Also, I am thinking that the laminations should be vertical, rather than horizontal.  This should make a stronger beam, and make the glue choice less important. 
1]    What wood species do you recommend?  What are its mechanical properties?
2]    Do you concur with vertical laminations?
Thanks in advance for your thoughts.
Stan R. Caldwell, P.E.
Vice President
8616 Northwest Plaza Drive
Dallas, Texas 75225
Phone: 214-346-6280
Fax: 214-739-0095