Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: 5/8" Anchor Bolts

[Subject Prev][Subject Next][Thread Prev][Thread Next]

On Feb 23, 2005, at 6:34 PM, Charley Hamilton wrote:

People have differing opinions about whether or not cut
threads are "as good as" rolled threads.
The best CW I get over here on the dark side is that rolled threads are preferred. The rolling operation makes for better mechanical properties in the direction of rolling, which is this case follows the surface of the thread. rolling doesn't leave tool marks transverse to the loading direction either. OTOH, a properly tightened bolt doesn't experience heavy cyclic loading so fatigue is less of a consideration. Most of the machine bolt ASTM specs permit both rolled and machined threads with some limits. A-574 for socket head screws specifies rolled threads only for diameters up to 5/8 and lengths up to 4 inches. Outside these limits threads may be rolled, cut or ground. A-574 screws are made from very strong material that isn't terribly tough; the rolled thread requirement appears to address fatigue and fracture requirements that are less critical for lower strength bolts.

Christopher Wright P.E. |"They couldn't hit an elephant at
chrisw(--nospam--at)   | this distance" (last words of Gen.
.......................................| John Sedgwick, Spotsylvania 1864)

******* ****** ******* ******** ******* ******* ******* ***
*   Read list FAQ at:
* * This email was sent to you via Structural Engineers * Association of Southern California (SEAOSC) server. To * subscribe (no fee) or UnSubscribe, please go to:
* Questions to seaint-ad(--nospam--at) Remember, any email you * send to the list is public domain and may be re-posted * without your permission. Make sure you visit our web * site at: ******* ****** ****** ****** ******* ****** ****** ********