Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

RE: Typical Stud Size for Embedded Plate

[Subject Prev][Subject Next][Thread Prev][Thread Next]

If the plate was just taking light gravity loads, depending on the attaching member dimensions, I have used like 3/8"x8" square plates with (4)-1/2" DIA x 4" or 5" LG headed studs.

For heavier loads, I have added rebar behind the embed for panel reinforcement due to bending, and if the plate was taking lateral loads, I have also welded bent rebar to the plate to drag the load back into the width of the panel.

 

Will

 


From: "Rich Lewis" <seaint03(--nospam--at)lewisengineering.com>
Reply-To: <seaint(--nospam--at)seaint.org>
To: <seaint(--nospam--at)seaint.org>
Subject: Typical Stud Size for Embedded Plate
Date: Thu, 18 Aug 2005 09:21:51 -0500

I?m looking to embed some plates in a concrete foundation wall to support some lightly loaded steel beams.  I would like to use headed studs welded to a plate.  What is the typical size of stud used for embedded plates?  What is typically used in precast or tilt-up panels for most common plates?  Is there a typical detail for rebar added in the local area of the studs?

 

Thanks!

 

Rich

 




Get MSN Messenger with Video Conversation - FREE. The next best thing to being there. ******* ****** ******* ******** ******* ******* ******* *** * Read list FAQ at: http://www.seaint.org/list_FAQ.asp * * This email was sent to you via Structural Engineers * Association of Southern California (SEAOSC) server. To * subscribe (no fee) or UnSubscribe, please go to: * * http://www.seaint.org/sealist1.asp * * Questions to seaint-ad(--nospam--at)seaint.org. Remember, any email you * send to the list is public domain and may be re-posted * without your permission. Make sure you visit our web * site at: http://www.seaint.org ******* ****** ****** ****** ******* ****** ****** ********