Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

RE: Expoxy type grout for anchor bolt

[Subject Prev][Subject Next][Thread Prev][Thread Next]

Does this allow for the large holes?  I couldn’t find any reference in my catalog that it was acceptable to use larger holes?  I assume the epoxy would shrink and crack in a large hole.  Perhaps I assume wrong.

 

Rich

 

 


From: David Fisher [mailto:dfisher(--nospam--at)fpse.com]
Sent: Tuesday, August 23, 2005 2:00 PM
To: seaint(--nospam--at)seaint.org
Subject: RE: Expoxy type grout for anchor bolt

 

Rich:

 

Try the Hilti “HY-150” threaded rods anchor system…

 

 

 

 

 

David L. Fisher  SE  PE

Senior Principal

Fisher + Partners Structural Engineers inc

372 West Ontario

Chicago 60610        

 

312.573.1701

312.573.1726 fax

312.622.0409 mobile

www.fpse.com        

 

David L. Fisher  SE  PE

Director

Head of Design and Construction

Cape Cod Grand Cayman Holdings Ltd

75 Fort Street

Georgetown Grand Cayman BWI

mobile 312.622.0409

www.ccgch.com

 

 

 

 

 

 

 

 

 

 

 


From: Rich Lewis [mailto:seaint03(--nospam--at)lewisengineering.com]
Sent: Tuesday, August 23, 2005 1:55 PM
To: seaint(--nospam--at)seaint.org
Subject: Expoxy type grout for anchor bolt

 

Is there a product for grouting anchor bolts in large holes?    Typically, from what I’ve seen, most epoxy anchor holes are slightly bigger than the bolt diameter. 

 

I have a project where the anchor bolts were not installed correctly.  The contractor wants to core 2-3” diameter holes for installing new bolts.  I was wondering if there was a product that would bond to the bolts and a hole that big.  The anchor diameters are ¾” & 1”.

 

Thanks.

 

Rich