Need a book? Engineering books recommendations...
Bolted Connection To Existing Old Steel[Subject Prev][Subject Next][Thread Prev][Thread Next]
- To: seaint(--nospam--at)seaint.org
- Subject: Bolted Connection To Existing Old Steel
- From: Daryl Richardson <h.d.richardson(--nospam--at)shaw.ca>
- Date: Mon, 13 Mar 2006 17:04:23 -0700
As some of you know, I am working on an important old heritage building. A problem detail which I would like to discuss with you has come up. The details follow.
An abandoned elevator shaft needs to be enlarged and returned to service. This will require removing an existing steel beam and replacing it with a new beam 1.5 to 2 feet away. The problem is that one end of the new beam must connect to an exterior beam which is encased in concrete as well as bricked over on the outside.
The obvious solution is to connect the flange of a T (perhaps fabricated from plate) to the existing steel and weld the web of the new beam to the stem of this T. The load in the order of five thousand pounds in shear (no tension). The devil is in the detail.
The easiest solution would be to weld the T to the existing web but I have a phobia against welding to very old steel.
Using a standard bolted connection would work but it would require six stories of scaffolding, concrete repair, brick repair lane blockage, construction permitting, and a lot of inconvenience. All very expensive and somewhat time consuming.
An other possibility is being considered; and on this I would like your thoughts. Do you think we could drill and tap the web of the existing beam from the inside only and use bolts like studs to make the connection? The web is probably between 0.25 and 0.375 inches thick. I have no problem installing four vertical rows of 3 or 4 bolts each (machine bolts, probably; A325 bolts could never be tensioned in the relatively thin, low strength web). I could even partially or fully weld the heads of the stud bolts to the flange of the new (fabricated) T to create fully fixed projecting dowels if desired.
Thank you for any comments you might choose to make.
H. Daryl Richardson
- Prev by Subject: Re: bolt force, round column.
- Next by Subject: Re: Bolted Connection To Existing Old Steel
- Previous by thread: Re: SOG gravel base topping
- Next by thread: Re: Bolted Connection To Existing Old Steel