Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: Concentrated Load at Edge of Pedestal

[Subject Prev][Subject Next][Thread Prev][Thread Next]
While it may or may not address your specific question, section 11.9 in
ACI 318 does deal with "special provisions for brakets and corbels".  I
would take a look at that section if you have not done so already.

Regards,

Scott
Adrian, MI


On Mon, 17 Jul 2006, Mike Zaitz wrote:

> I have a condition where I will have concentrated loads near the edge of the
> concrete pedestal under some latticed columns.  The pedestal is 4'-0" x
> 2'-0" with 2-W14x43 columns with the webs parallel to the short dimension.
> The centerlines (parallel to the web) are only 5 inches from the edge.  For
> this case my factored load is only 157 kips but on other areas they will be
> higher.  I have checked the bearing for the concrete and am trying to find
> anything for verifying that I will not spall the edge of the pedestal.  I do
> not find anything in the code (ACI 318-99) that addresses this condition
> (other than the concrete bearing).  Is there something I am missing?
>

******* ****** ******* ******** ******* ******* ******* ***
*   Read list FAQ at: http://www.seaint.org/list_FAQ.asp
* 
*   This email was sent to you via Structural Engineers 
*   Association of Southern California (SEAOSC) server. To 
*   subscribe (no fee) or UnSubscribe, please go to:
*
*   http://www.seaint.org/sealist1.asp
*
*   Questions to seaint-ad(--nospam--at)seaint.org. Remember, any email you 
*   send to the list is public domain and may be re-posted 
*   without your permission. Make sure you visit our web 
*   site at: http://www.seaint.org 
******* ****** ****** ****** ******* ****** ****** ********