Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: Caliche Soil Bearing in UT

[Subject Prev][Subject Next][Thread Prev][Thread Next]
I've inspected numerous concrete block buildings in Las Vegas.  Caliche is a big problem with differential movement and breaking up these buildings and the slabs on grade floors.    I would insist on a soil report.

Also, much of the soil in Las Vegas is "hot" - meaning that you'll have to use higher strength concrete and lower water cement ratios.  Check with either the building department.   We did a lot of monopoles there and these were standard requirements per the building department as far as the concrete was concerned.

I don't think that Utah caliche problems would be any different.

Check this out:

Neil Moore, SE, SECB
neil moore and associate
shingle springs, ca

distressed structures investigations

At 09:34 AM 10/18/2006, Rich Lewis wrote:
I?m working in the blind right now.  I have a project I?m starting in Varnel, Utah which is the NE corner of the state.  Some geotechnical work was done for perk test.  No official borings.  The person who did the perk tests bored down twice to 10 ft.  He said the soil is all Caliche.  I have not dealt with this type of soil before.  I understand it is a hard packed mixture of sand, clay and silt.  When the owner asked for a price for doing foundation geotechnical investigation the geotech said ?Why would you need any additional information?  The ground around here will hold up any building?.
Can someone who has experience with caliche in the Utah area tell me if this stuff is wonderful for foundations?  What are typical bearing values for this stuff?  Are there any precautions in using it that I should be aware of?  Are geotech reports usually prepared or do you just put buildings up on it?
Thanks for your help.