Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Nelson Studs

[Subject Prev][Subject Next][Thread Prev][Thread Next]

Hi,

I have a few queries on the H4L and S4L  Nelson studs.

1. No weld height and diameter is shown for the above studs in the catalogues. How are these to be calculated.? What strengths do these develop- full stud strength?
I presume that the welding is done by a gun- In this case can the weld dimensions be varied ? Is it necessary to use a gun of a normal weld process can  be used to deposit
a fillet weld?

2. If the studs are part of an Embed plate is it preferable to get the whole assembly hot dip galvanized after welding of the studs? Or should the studs be ordered zinc plated from the manufactures and then welded onto a galvanized embed plate?

Thanks
S.Sehdev

-----------------------------------------------------------------------------------------------------
The information transmitted is intended only for the person
or entity to which it is addressed and may contain proprietary,
business-confidential and/or privileged material.
If you are not the intended recipient of this message you
are hereby notified that any use, review, retransmission,
dissemination, distribution, reproduction or any action taken
in reliance upon this message is prohibited. If you received
this in error, please contact the sender and delete the
material from any computer. Any views expressed in this message
are those of the individual sender and may not necessarily reflect
the views of the company.
-------------------------------------------------------------------------------------------------------