Need a book? Engineering books recommendations...
Aluminum Rectangular Tubing[Subject Prev][Subject Next][Thread Prev][Thread Next]
- To: seaint(--nospam--at)seaint.org
- Subject: Aluminum Rectangular Tubing
- From: "Gerard Madden, SE" <gmse4603(--nospam--at)gmail.com>
- Date: Fri, 5 Jan 2007 12:54:37 -0800
Couple of quick questions.
What is the alloy number in the 6061 series that is common used for 2" - 4" square and rectangular aluminum tubes? Is it 6061-T1 or -T5 ? Or some other one?
I went to Alcoa's website and they have good info, but they have Rectangular Tubes with Rounded Edges and and Rectangular Tubes with Square Edges. Both are extruded. not sure which one is more common.
Basically, what I'm after is THE MOST COMMON aluminum for 2x2 square tubes. So I'm not sure which alloy that is and which edge type. I take it that all aluminum shapes are extruded, not hot-rolled like steel.
This is for some small decorative attachment mountings for a building.
- Prev by Subject: RE: Allowable Out-of-Plane Lateral Deflections of Masonry Veneers
- Next by Subject: Re: Aluminum Rectangular Tubing
- Previous by thread: Re: PE Exam
- Next by thread: Re: Aluminum Rectangular Tubing