Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: Aluminum Rectangular Tubing

[Subject Prev][Subject Next][Thread Prev][Thread Next]
The only alloy my local supplier (VA - BMG metals) stocks is 6063-T52 in rectangular and square. 2" tube is listed at 1/8, 3/16, 1/4 thicknesses.
Jordan


Gerard Madden, SE wrote:
To follow up, from CBC Table 20-II-A,

It appears that "DRAWN TUBE" is 6061-T6

Is that the common aluminum type I should be using?

thanks again.
-g

On 1/5/07, Gerard Madden, SE <gmse4603(--nospam--at)gmail.com> wrote:
Couple of quick questions.

What is the alloy number in the 6061 series that is common used for 2" - 4" square and rectangular aluminum tubes? Is it 6061-T1 or -T5 ? Or some other one?

I went to Alcoa's website and they have good info, but they have Rectangular Tubes with Rounded Edges and and Rectangular Tubes with Square Edges. Both are extruded. not sure which one is more common.

Basically, what I'm after is THE MOST COMMON aluminum for 2x2 square tubes. So I'm not sure which alloy that is and which edge type. I take it that all aluminum shapes are extruded, not hot-rolled like steel.

This is for some small decorative attachment mountings for a building.

tia

--
-gm



--
-gm
******* ****** ******* ******** ******* ******* ******* *** * Read list FAQ at: http://www.seaint.org/list_FAQ.asp * * This email was sent to you via Structural Engineers * Association of Southern California (SEAOSC) server. To * subscribe (no fee) or UnSubscribe, please go to: * * http://www.seaint.org/sealist1.asp * * Questions to seaint-ad(--nospam--at)seaint.org. Remember, any email you * send to the list is public domain and may be re-posted * without your permission. Make sure you visit our web * site at: http://www.seaint.org ******* ****** ****** ****** ******* ****** ****** ********