Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: Old Steel Shapes

[Subject Prev][Subject Next][Thread Prev][Thread Next]
Glenn -

AISC formerly had a publication titled "Iron and Steel Beams, 1873 to 1952'
that contained properties for the different sections from different
manufacturers.  I believe this has now been superceded by their 'Steel
Design Guide 15:  AISC Rehabilitation and Retrofit Guide', which contains
the properties mentioned above along with some other information.  I would
recommend getting this Design Guide to give you a more complete picture of
the section properties, since the steel sections in 1940 weren't
necessarily equal from different manufacturers.


Bradford L. Burton, P.E.
Senior Structural Project Engineer
Ellerbe Becket, Inc.
1001 G Street, NW
Suite 1000
Washington, DC 20001-4522
Tel:  202-654-9238
Fax: 202-654-9301


                                                                           
             "Glenn Otto"                                                  
             <ggator1256@cox.n                                             
             et>                                                        To 
                                       <seaint(--nospam--at)seaint.org>                 
             01/21/2007 02:38                                           cc 
             PM                                                            
                                                                   Subject 
                                       Old Steel Shapes                    
             Please respond to                                             
             <seaint(--nospam--at)seaint.or                                             
                    g>                                                     
                                                                           
                                                                           
                                                                           










I’ve got some drawings from 1940 calling out steel “B” shapes.  I could
list the ones for which I need properties, (about 10), but I thought I
would try to get a manual off of eBay.  Presently, I see a 1930, its says
it’s a AISC 1st edition, and a couple of 1948 manuals, 4th edition?  Would
those be close enough?  Would I need a manufacturer’s manual?





Thanks,



A Structural Engineer
Glenn C. Otto, P.E.
2108 Flowerdew Ct.
Virginia Beach, VA 23454
757-477-2319




�����������������������������������������Pj�����)��������ӆ+����,z{m�*.�&������I��������b�zJ�����b~�牯����r��{���'J���{���h������)����+-����й��춋j)���梞���g�m�|����ʋ����azX��+)��bq�j)ڝٚɷ�{������ʋ������G������+h��o��m������梞���������������������������������������