Need a book? Engineering books recommendations...
RE: Retaining Wall with Key[Subject Prev][Subject Next][Thread Prev][Thread Next]
- To: <seaint(--nospam--at)seaint.org>
- Subject: RE: Retaining Wall with Key
- From: <William.Sherman(--nospam--at)CH2M.com>
- Date: Tue, 17 Jul 2007 14:29:52 -0600
I looked at an older CRSI edition, but I didn't see anything that clarified the situation.
CH2M HILL / DEN
From: gloomis(--nospam--at)MasterEngineersinc.com [mailto:gloomis(--nospam--at)MasterEngineersinc.com]
Sent: Monday, July 16, 2007 9:08 AM
Subject: RE: Retaining Wall with Key
Have you looked at Chapter 14 – Cantilevered Retaining Walls, of CRSI Design Handbook? I have the 1996 edition and may answer your questions.
Gary W. Loomis, P.E., Senior Structural Engineering
Master Engineers and Designers, Inc.
I have been searching for a rational load analysis of a retaining wall with a key into the supporting soil for years, but I have not found a satisfactory solution yet. Hoping someone on this list can offer something to help resolve this issue.
Many references on foundation design indicate that a keyway extended below a retaining wall into the soil will enhance the sliding stability by engaging more passive pressure for resistance. But they do not explicitly address the soil pressure on the driving side of the keyway. This is often interpreted to mean that only the passive pressure is considered at the keyway. What happened to "free-body diagrams"? What is the basis to neglect loads on the driving side of the keyway? (Many software programs use this questionable assumption for retaining wall design with keyways.)
If significant movement of the wall is permissible and loads are transient, it might be argued that the keyway moves away from the soil and leaves a gap. But for sustained loads, the gap is likely to fill in over time and re-establish a driving soil pressure on the keyway. Also, for a centrally located keyway, there is a vertical surcharge force on the soil due to bearing pressure from the wall base that may push the soil against the keyway.
Load diagrams in EM 1110-2-2502, Retaining and Flood Walls, by the USACE, do show the driving side soil pressure to be extended to the bottom of the keyway (i.e., a true fee-body diagram with applied loads). This is the approach I generally use - but it makes the heel on some retaining walls rather long!
If minimal movement is desirable and at-rest soil pressures are used on the driving side, it is possible for the at-rest pressures on the keyway to exceed the passive pressures on the keyway (due to higher soil depth on the driving side). This implies that the keyway makes the wall less stable!
Thus, I have concluded that using a full driving side soil pressure on the keyway may be excessively conservative, but that no driving side soil pressure is overly unconservative. I'm looking for a rational method that falls somewhere between these two extremes.
William Sherman - CH2M HILL / Denver
Structural Technology Discipline Leader (TeD)
Engineering Design Group - Civil / Federal Engineering (EDG-CFE)
- RE: Retaining Wall with Key
- From: gloomis
- RE: Retaining Wall with Key
- Prev by Subject: Re: Retaining Wall with Key
- Next by Subject: RE: Retaining Wall with Key
- Previous by thread: RE: Retaining Wall with Key
- Next by thread: Retaining Wall with Key