Need a book? Engineering books recommendations...

# RE: October Structural Engineer " Resisting Lateral Forces Cumulative overturning design"

• To: <seaint(--nospam--at)seaint.org>
• Subject: RE: October Structural Engineer " Resisting Lateral Forces Cumulative overturning design"
• From: "Jeff Smith" <jeffsmith7(--nospam--at)comcast.net>
• Date: Tue, 6 Nov 2007 13:20:08 -0800

```Funny...I was just watching this simpson strong tie video:
http://www.strongtie.com/overturn/index.asp   which is how I have always
done it.

My October Structural Engineer is in the same place, thanks for bringing
that to my attention.

Jeff

-----Original Message-----
From: Haan, Scott M POA [mailto:Scott.M.Haan(--nospam--at)poa02.usace.army.mil]
Sent: Tuesday, November 06, 2007 12:42 PM
To: seaint(--nospam--at)seaint.org
Subject: October Structural Engineer " Resisting Lateral Forces Cumulative
overturning design"

Last night I finally pulled the October 2007 Structural Engineer magazine
off the flush tank and read the  " Resisting Lateral Forces Cumulative
overturning design..."

The author says that wood shear wall overturning forces  should be based on
the moment arm from the center of the compression chord to the center of the
anchor rod, fine...  The article says that the only way to get accurate
overturning forces for a multistory wood shear wall is to calculate the
overturning moments and draw a free body diagram of the multi-story wall.

The article says that using the unit shear times height method understates
the uplift for multistory walls and is only for preliminary approximations,
uh. uh. if you do it right.

The unit shear times height method is derived with a free body diagram and
summing moments. It assumes forces are distributed to walls proportional to
their lengths. If you add the tension from the wall above to the tension to
the wall chord below and use the full floor to floor heights and subtract
out the tributary resisting loads you get the exact same result. If the
problem is the moment arm is too long, you would be conservative by either
designing with the wall lengths as the moment arm length to calculate your
unit shear or dividing your tension by the ratio of the moment arm length to
wall panel length. I say to anyone who disagrees with this to draw a free
body diagram and sum the moments.

hassles for design engineers.

******* ****** ******* ******** ******* ******* ******* ***
*   Read list FAQ at: http://www.seaint.org/list_FAQ.asp
*
*   This email was sent to you via Structural Engineers
*   Association of Southern California (SEAOSC) server. To
*   subscribe (no fee) or UnSubscribe, please go to:
*
*   http://www.seaint.org/sealist1.asp
*
*   Questions to seaint-ad(--nospam--at)seaint.org. Remember, any email you
*   send to the list is public domain and may be re-posted
*   site at: http://www.seaint.org
******* ****** ****** ****** ******* ****** ****** ********

******* ****** ******* ******** ******* ******* ******* ***
*   Read list FAQ at: http://www.seaint.org/list_FAQ.asp
*
*   This email was sent to you via Structural Engineers
*   Association of Southern California (SEAOSC) server. To
*   subscribe (no fee) or UnSubscribe, please go to:
*
*   http://www.seaint.org/sealist1.asp
*
*   Questions to seaint-ad(--nospam--at)seaint.org. Remember, any email you
*   send to the list is public domain and may be re-posted