Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: Transfer Girder Design having more Depth

[Subject Prev][Subject Next][Thread Prev][Thread Next]
Title: Re: Transfer Girder Design having more Depth
You should be able to use the provisions from ACI 318 to design the beam.  Assuming you don’t have “weird” loading, your beam would NOT be considered a “deep beam” by ACI 318 (a “deep beam” under ACI 318 provisions is a beam where the span of the beam is less than 4 times the your case, the span would have to be less than 12 meters for a 3 meter deep beam...or a roughly 4.5 m deep beam for the 18 m span).  FWIW, there is a metric version of ACI 318 as well.


Adrian, MI

On 11/14/07 1:46 AM, "Samiappan Srinivasan" <ssrinivasan(--nospam--at)> wrote:


I am designing a Transfer Girder, having Size of 1750 x 3000. To find Area of Reinforcement, I am considering only Bending Moment. (Span of Beam is 18m)

Is there any special condition, I have to check. Because the Depth of Beam is 3m.

What is the Maximum Depth for Beam Members?.

Can anybody having the design experiences share some knowledge?

Thanks in advance.

Best Regards,

"This Message and its contents is intended solely for the addressee and is proprietary.Information in this mail is for L&T Business Usage only. Any Use to other than the addressee is misuse and infringement to Proprietorship of L&T ECC.If you are not the addressee please return the mail to the sender.L&T ECC DIVISION"