Need a book? Engineering books recommendations...
RE: Concrete Masonry Arch[Subject Prev][Subject Next][Thread Prev][Thread Next]
- To: <seaint(--nospam--at)seaint.org>
- Subject: RE: Concrete Masonry Arch
- From: "Michelle Motchos" <mmotchos(--nospam--at)sw-sc.com>
- Date: Fri, 20 Jun 2008 09:23:25 -0400
Depending on the total rise/width (and backup requirements for the brick) you could consider trying a Halfen arch for the aesthetic face (http://www.halfenusa.com/masonry01_lintel00.html) which may allow you to just place a standard straight cmu lintel just above the crown.
Powers also has some interesting lintels for brick and cmu that might be of use since it is not likely that the brick will be in place when it comes time to form the arch out of the cmu (http://www.powerssteel.com/lintels.html )
Michelle Motchos, PE
From: Rich Lewis
I’m looking for detailing tips and insight in concrete masonry arch construction. I have a project where the architect has shown several masonry arches. The wall construction is 8” CMU and a brick veneer. I have seen many brick arches built but I have never seen a concrete masonry wall arch built. I have some opening in the 15 feet span range.
I have NCMA TEK 14-14 which states the arch should be made of solid CMU or the CMU should be grouted solid. I see the steps to construct the arch as being:
1. Install arch form
2. Create the first row of the arch using brick, either clay or concrete. The architect will determine that.
3. Build the brick veneer arch as a typical brick arch.
4. Build the CMU backup arch using cut block. I would assume hollow block.
5. Grout the arch solid up to the crown height
6. Put in a bond beam course directly above the crown.
7. Build the wall above the arch as a typical wall.
I’m wondering if I should put some steel bars in that follow the arch curve, directly above the first row of bricks. I know this area is in compression so I don’t see much use of the steel. I’m also wondering if I should have some vertical steel in the arched section of wall, between the bond beam and the first row, above the spring line.
I open to suggestions for detailing CMU arches.
- Concrete Masonry Arch
- From: Rich Lewis
- Concrete Masonry Arch
- Prev by Subject: RE: Concrete Masonry Arch
- Next by Subject: Concrete Specs for Composite HSS
- Previous by thread: RE: Concrete Masonry Arch
- Next by thread: Federal Project - Seismic Question