Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: varying shear flow in concrete beam.

[Subject Prev][Subject Next][Thread Prev][Thread Next]
Mike:
 
You may want to consult some of the Fiber Wrap representatives. They could help with both bending and shear capacity.
 
Farzin S. Rahbar, SE
David C. Weiss Structural Engineer & Associates, Inc.
(818) 227-8040 Ex. 13 Fax: (818) 227-8041
 
In a message dated 10/20/2008 1:06:06 P.M. Pacific Daylight Time, Michael.Laplante(--nospam--at)cima.ca writes:
I have a situation were an existing vertical concrete beam (not a column but a pier with hydrostatic forces) that needs reinforcing. The thought is to scab on a reinforced section the will have  tension reinforcement for flexture and shear reinforcement that will be tied back into the compression zone of the existing pier.  My question.... does the shear flow at the interface between the two sections ( old and new) vary along the height?  All the references that I have consulted gave examples for  simply supported steel beams that are  welded or bolted. These fasteners were designed  based on the support reactions and  distrubuted evenly along the interface. 
 
Mike