Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: Anchor rod washers

[Subject Prev][Subject Next][Thread Prev][Thread Next]
Bill,
 
This table may (and not necessarily will) work only for the "standard" oversize. 
 
According to Section "Washer Requirements" (page 14-10), the washer "thickness must be suitable for the forces transferred."  In my understanding, that thickness was the original question.
 
V. Steve Gordin, SE
Irvine CA
 
   
----- Original Message -----
Sent: Thursday, June 25, 2009 14:02
Subject: RE: Anchor rod washers

Table 14-2 in AISC Manual, 13th Edition.  Base plate holes are oversized, washer holes are standard size.
 
Bill Sherman
CH2M HILL / DEN
720-286-2792
 


From: Drew Morris [mailto:dmorris(--nospam--at)bbfm.com]
Sent: Thursday, June 25, 2009 2:25 PM
To: SEAINT
Subject: Anchor rod washers

I am trying to track down the recommended washer plate thickness for anchor rods.  Typically the holes are oversized and I am trying to find the thickness for the washers.  i assume it is some percentage of the rod diameter.  Can anyone direct me to where i can this info?