Need a book? Engineering books recommendations...
RE: Point load on garage diaphragm[Subject Prev][Subject Next][Thread Prev][Thread Next]
- To: <seaint(--nospam--at)seaint.org>
- Subject: RE: Point load on garage diaphragm
- From: "Gordon Goodell" <GordonGoodell(--nospam--at)harmonydesigninc.com>
- Date: Tue, 4 Aug 2009 11:23:27 -0600
Title: RE: Point load on garage diaphragm
My copy of this came through as all symbols. Did everyone else get it that way? We’ve been experiencing some email weirdness for the last week or so, since we switched to a new host/service provider.
Read the ASCE commentary on concentrated live loads, C4.3. The answer to your question is no, you are not required to design the plywood for 3000# over 4.5"x4.5"; that provision is intended to apply only to primary framing members. You don't necessarily even have to design the floor joist for it, as it is a repetitive member, and the failure of one joist would not cause a collapse.
HOWEVER, this load is designed to mimic a floor jack lifting a car, which seems likely on your floor, so aside from what you are required to do, I would design all components for this load. And I would use normal-wt concrete w/ bars to distribute this load among members (and take care of plywood concerns). Your wearing surface will be much more durable, too.
- Prev by Subject: RE: Point load on garage diaphragm
- Next by Subject: Re: Point load on garage diaphragm
- Previous by thread: RE: Point load on garage diaphram
- Next by thread: Re: Point load on garage diaphragm