Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

RE: Signs for Response Spectrum Analysis

[Subject Prev][Subject Next][Thread Prev][Thread Next]
Parag - 

If you have a mode that "dominates" over the other modes then you should be
able to use the relative signs of that mode to determine which members are
in tension or compression and such.  You'll probably still want to use two
LC's for each of the EQ loads. At least when you're designing a combined
footing for a moment frame then your analysis won't try to tell you that
both columns are in uplift at the same time.

For what it's worth RISA-3D does give the user the option of using the
dominant mode to provide signage to the RSA results..... The real judgment
call then is what constitutes a "dominant" mode.  Certainly a model with 90%
mass participation would.  Probably a single mode with 75% mass
participation would as well.  But, once you start getting below that it
becomes questionable. 

Sincerely, 

Josh Plummer, SE
RISA Technologies

******
From: Parag Bande <pabande(--nospam--at)npcil.co.in>
To:  seaint(--nospam--at)seaint.org
Subject: Signs for Response Spectrum Analysis

Dear All,
In Response Spectrum Analysis (RSA), due to modal combinations (CQC or 
SRSS) signs for the member reactions/forces gets lost. Is there any 
accepted methodology to apply signs to these forces during load 
combination ? When EQ load is subtracted from other loads in load 
combination it means that direction for concern EQ is reversed. However  
structural response for any kind of horizontal load one cannot get all 
members (forces) behaving similar manner, means all bending cannot be 
hogging/sagging or all members cannot be in compression/tension.
Thanks in advance
Regards,
Parag



******* ****** ******* ******** ******* ******* ******* ***
*   Read list FAQ at: http://www.seaint.org/list_FAQ.asp
* 
*   This email was sent to you via Structural Engineers 
*   Association of Southern California (SEAOSC) server. To 
*   subscribe (no fee) or UnSubscribe, please go to:
*
*   http://www.seaint.org/sealist1.asp
*
*   Questions to seaint-ad(--nospam--at)seaint.org. Remember, any email you 
*   send to the list is public domain and may be re-posted 
*   without your permission. Make sure you visit our web 
*   site at: http://www.seaint.org 
******* ****** ****** ****** ******* ****** ****** ********