Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: Guard Rails

[Subject Prev][Subject Next][Thread Prev][Thread Next]
I though the top rail diameter shall be less than 2" and continue just in case for the handicap person to put their hand on the rail.  This rail could be located on the top or the side of the guardrail or ramp and continue to assist handicap person.

From: "Rhkratzse(--nospam--at)" <Rhkratzse(--nospam--at)>
To: vicpeng(--nospam--at); seaint(--nospam--at)
Sent: Wednesday, September 9, 2009 1:53:40 PM
Subject: Re: Guard Rails

I have no idea, but I would like to point out that I often seen, mainly in architectural magazines, stairs with all-glass railings, without a continuous top trim, with trapezoidal-shaped glass panels with a point at the upper corner.  Meaning that if you slide your hand down the rail, it'll be impaled on that point.  Can't understand how that can be acceptable.


In a message dated 9/9/09 1:29:08 PM, vicpeng(--nospam--at) writes:
Can anyone confirm for me, under any/all US codes, if a continuous top rail
is mandated on all glass "guard rail" systems?  . if it's a judgement call
or if it's not even mentioned .


Thor A. Tandy P.Eng, C.Eng, Struct.Eng, MIStructE
Victoria, BC