Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

re: wind on solar panels

[Subject Prev][Subject Next][Thread Prev][Thread Next]
Mark,
I would look at the solar panels two different ways, depending on how they are mounted. If they are mounted flush to the roof surface, like most water solar panels for pools and hot water heaters, then I would likely use roof pressures. If they are mounted off the roof on racks at angles, such as for direct electrical production (which I am assuming is your case), I would likely analyze them using ASCE open canopy pressures. I don't have access to it at the moment but this should result in lower uplift pressures than if you used roof pressures, so I guess you could be conservative and use roof pressures. You will also have a horizontal component if the panels are angled. Using a more conservative approach would only result in a slight cost increase in your connections and supports either way, and compared to the value of the solar panels and equipment,and the cost of loss of use of the panels, I would definitely err on the conservative side. 

Regards,
Andrew Kester, PE
Florida

******* ****** ******* ******** ******* ******* ******* ***
*   Read list FAQ at: http://www.seaint.org/list_FAQ.asp
* 
*   This email was sent to you via Structural Engineers 
*   Association of Southern California (SEAOSC) server. To 
*   subscribe (no fee) or UnSubscribe, please go to:
*
*   http://www.seaint.org/sealist1.asp
*
*   Questions to seaint-ad(--nospam--at)seaint.org. Remember, any email you 
*   send to the list is public domain and may be re-posted 
*   without your permission. Make sure you visit our web 
*   site at: http://www.seaint.org 
******* ****** ****** ****** ******* ****** ****** ********