Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

RE: A.S.C.E.

[Subject Prev][Subject Next][Thread Prev][Thread Next]

I go by the golden rule.  I was taught it by my boss over 20 years ago.


“He who has the gold rules”


It solves a lot of perceived problems.


Your boss is (almost) always right  :o)





From: erik [mailto:erik_g(--nospam--at)]
Sent: Saturday, October 02, 2010 12:34 PM
To: seaint(--nospam--at)
Subject: A.S.C.E.


In A.S.C.E. when talking about different lateral force resisting systems the second sentence says, “Resisting elements are permitted to be designed using the least value of R for the different structural systems founds in each INDEPENDENT line of resistance if the following 3 conditions are met…..


If those 3 conditions are met I take this to mean that if you have an ordinary moment frame w/ R=3.5 and a plywood shearwall w/ R=6.5 in the same line, say line ‘A’, and line ‘B’ is an independent line of resistance comprised of plywood shearwall’s, then the lateral forces in line ‘A’ are designed with R=3.5 and line ‘B’ can be designed w/ R=6.5!


As I read this section I see that they drew a distinction between the same direction & independent lines in the same direction. Why else would this be put into the code, especially since it applies to most light framed residential structures?


My boss says that this does not mean that, and that just because I might use a moment frame in the N-S direction of a single story residence, then all the other shearwalls in the N-S direction must be designed with R=3.5, but I disagree. For residential where the risk of life is fairly small, and the structure is fairly light  I think that this is way too conservative, since the forces that are designed for are only approximations based of statistical values. 


Any thoughts on this?




Erik Gibbs  


No virus found in this incoming message.
Checked by AVG -
Version: 9.0.862 / Virus Database: 271.1.1/3185 - Release Date: 10/08/10 13:34:00