Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: Interior wood shear wall lateral bracing

[Subject Prev][Subject Next][Thread Prev][Thread Next]
It sounds like the shear transfer from the truss to the shear wall is the only mechanism holding the wall upright.  Should that fail, there are no belts and suspenders to keep the wall from falling over.  Even if the loading is low, in this case, just bite the bullet and add blocking at 4'-0" max.  Just remember that a lot can happen between plan approval and construction, like the framer using 8d shorts at the L50 clips through a 3/8" ply shim because he built the wall too short.  Nail pullout = wall falldown.

On Wed, Dec 7, 2011 at 11:21 AM, Jeff Hedman <jeff_h(--nospam--at)lrpope.com> wrote:

I guess my point is, if sheetrock/purlins are sufficient bracing for the trusses, why is it not an acceptable bracing for a shear wall?  Especially in this case where both the in plane lateral loads and out of plane loads are so low.

 

Jeff Hedman , S.E.

email logo

L.R. Pope Engineering, Inc.

1240 East 100 South Suite # 15B

St. George, Utah  84790

Office: 435-628-1676

Fax: 435-628-1788

email: jeff_h(--nospam--at)lrpope.com

 

This email message, including any attachments, is for the sole use of the intended recipient(s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution of this information is prohibited, and may be punishable by law. If you have received this electronic mail transmission in error, please notify the sender by reply e-mail or by telephone and destroy all contents of the original message on all computers or hard copies.

 




--
David Topete, SE