Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: Blast Door Design : Edge Rotation

[Subject Prev][Subject Next][Thread Prev][Thread Next]
The UFC states why the 2 degrees is imposed such as for panic hardware and
seal requirements when protecting personnel. Page 1499 mentions this.

On Mon, Oct 29, 2012 at 3:26 PM, Kapil Nandwana 
<kapil.nandwana(--nospam--at)gmail.com>wrote:

> Hi,
> 
> The provision for deformation and ductility criterion is taken from
> UFC-3-340-02 (http://www.wbdg.org/ccb/DOD/UFC/ufc_3_340_02_pdf.pdf),
> Chapter 5, Pg 1496, Summary of deformation criterion.
> 
> Yes, the door has panic hardware in it. Basically they are a bunch of
> rebound pins.
> 
> The door that I am working on is big (15'x16') double leaf door, each 
> leaf of which can only supported on two side (top and side). It is a 
> monolithic plate. If a built door is the answer to this problem then can 
> how should I design my vertical stiffener of the door plate given that it 
> can only be supported on one side ?
> 
> On Mon, Oct 29, 2012 at 2:36 PM, Himanshu Goyal
> <anshuagoel(--nospam--at)gmail.com>wrote:
> 
>> Hello:
>> 

Truncated 850 characters in the previous message to save energy.

-------------------------------------------------------------------------
Post your message to the list by sending it to: 
   SEAINT-SEAOSC(--nospam--at)mail-list.com.

The email messages sent to the list will be saved in an archive on the World Wide Web.
These archives are located at:
    http://archive.mail-list.com/SEAINT-SEAOSC

To contact the list owner, send your message to:
   SEAINT-SEAOSC-list-owner(--nospam--at)mail-list.com.

5700 Ralston Street, Suite 300, Ventura, CA 93003

To unsubscribe, switch to/from digest, get on/off vacation, or change your email address, click here.
http://cgi.mail-list.com/u?ln=seaint-seaosc&nm=seaintma%40euken.net