Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

RE: Fwd: Single Plate LST Holes

[Subject Prev][Subject Next][Thread Prev][Thread Next]
Charlie,

Yes.  The AISC 360, Secton 10. Bearing Strength at Bolt Holes has 
provisions for calculating the strength normal to the slot.

I am not sure what you mean by an "ST" joint.

Regards, Harold Sprague

> From: canitzcf(--nospam--at)aol.com
> Date: Tue, 8 Jan 2013 23:56:47 -0500
> Subject: [SEAINT-SEAOSC] Fwd: Re: Single Plate LST Holes
> To: seaint-seaosc(--nospam--at)mail-list.com
> 
> Are long slotted holes prohibited for single plate connections if the 
> holes are oriented normal to the design load?
> 
> Furthermore, can a ST joint be used in this situation if a continuous PL
> type washer is placed over the slotted holes?
> 
> Thanks,
> Charlie Canitz, PE
> 
> -----Original Message-----
> From: Canitz, Charles NAB <Charles.F.Canitz(--nospam--at)usace.army.mil>
> To: 'canitzcf(--nospam--at)aol.com' <canitzcf(--nospam--at)aol.com>
> Sent: 08-Jan-2013 23:51:26 +0000
> Subject: Re: Single Plate LST Holes
> 

Truncated 623 characters in the previous message to save energy.

-------------------------------------------------------------------------
Post your message to the list by sending it to: 
   SEAINT-SEAOSC(--nospam--at)mail-list.com.

The email messages sent to the list will be saved in an archive on the World Wide Web.
These archives are located at:
    http://archive.mail-list.com/SEAINT-SEAOSC

To contact the list owner, send your message to:
   SEAINT-SEAOSC-list-owner(--nospam--at)mail-list.com.

5700 Ralston Street, Suite 300, Ventura, CA 93003

To unsubscribe, switch to/from digest, get on/off vacation, or change your email address, click here.
<http://cgi.mail-list.com/u?ln=seaint-seaosc&nm=seaintma%40euken.net>