Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

RE: Fwd: Single Plate LST Holes

[Subject Prev][Subject Next][Thread Prev][Thread Next]
Charlie,
The snug tight condition would be a bearing bolt, and you can use them in 
the direction perpendicular to the slot within the limitations in AISC 360, 
 Section 10.  If you need to resist load parallel to the slot, it would 
have to be slip critical.  Again it is defined in Section 10.

Regards, Harold Sprague

> From: canitzcf(--nospam--at)aol.com
> Date: Thu, 10 Jan 2013 15:42:35 -0500
> Subject: Re: [SEAINT-SEAOSC] Fwd: Single Plate LST Holes
> To: seaint-seaosc(--nospam--at)mail-list.com
> 
> Harold -
> 
> Thanks.
> 
> ST = Snug Tight. Due to the long slotted holes, I was wondering if the
> ST type connection was OK or if a slip critical type connection is 
> required for this situation.
> 
> Charles Canitz
> 
> -----Original Message-----
> From: Harold Sprague <spraguehope(--nospam--at)hotmail.com>
> To: seaint-seaosc <seaint-seaosc(--nospam--at)mail-list.com>
> Sent: Wed, Jan 9, 2013 2:48 pm
> Subject: RE: [SEAINT-SEAOSC] Fwd: Single Plate LST Holes

Truncated 719 characters in the previous message to save energy.

-------------------------------------------------------------------------
Post your message to the list by sending it to: 
   SEAINT-SEAOSC(--nospam--at)mail-list.com.

The email messages sent to the list will be saved in an archive on the World Wide Web.
These archives are located at:
    http://archive.mail-list.com/SEAINT-SEAOSC

To contact the list owner, send your message to:
   SEAINT-SEAOSC-list-owner(--nospam--at)mail-list.com.

5700 Ralston Street, Suite 300, Ventura, CA 93003

To unsubscribe, switch to/from digest, get on/off vacation, or change your email address, click here.
<http://cgi.mail-list.com/u?ln=seaint-seaosc&nm=seaintma%40euken.net>