Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

RE: Bent Plate Versus Rolled Angle

[Subject Prev][Subject Next][Thread Prev][Thread Next]
Please note also, that "stress" isn't the same as "strength."

> On April 16, 2013 at 11:23 AM Craig Hawe <chawe(--nospam--at)norwestcorp.com> wrote:
> 
> 
> Stress are determined by Area, Moment of Inertia, material properties, 
> and Section Modulus.

-------------------------------------------------------------------------
Post your message to the list by sending it to: 
   SEAINT-SEAOSC(--nospam--at)mail-list.com.

The email messages sent to the list will be saved in an archive on the World Wide Web.
These archives are located at:
    http://archive.mail-list.com/SEAINT-SEAOSC

To contact the list owner, send your message to:
   SEAINT-SEAOSC-list-owner(--nospam--at)mail-list.com.

Sponsored By: Pacific Structural & Forensic Engineers Group, Inc. (PSFEG)

To unsubscribe, switch to/from digest, get on/off vacation, or change your email address, click here.
<http://cgi.mail-list.com/u?ln=seaint-seaosc&nm=seaintma%40euken.net>