Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: L-shaped A490 Anchor Bolts

[Subject Prev][Subject Next][Thread Prev][Thread Next]
All,

     I usually call out the tack on the "unloaded" side of the nut. That is 
 to say on the face closest to the "dead" end of the rod.

- Mike

Bill Polhemus <bill(--nospam--at)polhemus.cc> wrote:

> Except I'm not sure the stress level at this location ever approaches the
> point where a fracture is initiated.
> 
> William L. Polhemus, Jr. P.E.
> 
> 5
> 
> On May 3, 2013, at 7:00 AM, Jim Getaz <jgetaz(--nospam--at)shockeyprecast.com> wrote:
> 
>> Bill,
>> Tack welding is always bad form unless the tack is later incorporated
>> into a full weld pass. Tack welds can be so small as to be the 
>> equivalent of an arc strike causing cracking. HTH, Jim Getaz
>> Winchester, Virginia
>> 
>> -----Original Message-----
>> From: seaint-seaosc(--nospam--at)mail-list.com [mailto:seaint-seaosc(--nospam--at)mail-list.com] 
>> On Behalf Of Bill Polhemus Sent: Friday, May 03, 2013 6:00 AM
>> To: seaint-seaosc(--nospam--at)mail-list.com
>> Subject: Re: [SEAINT-SEAOSC] L-shaped A490 Anchor Bolts

-------------------------------------------------------------------------
Post your message to the list by sending it to: 
   SEAINT-SEAOSC(--nospam--at)mail-list.com.

The email messages sent to the list will be saved in an archive on the World Wide Web.
These archives are located at:
    http://archive.mail-list.com/SEAINT-SEAOSC

To contact the list owner, send your message to:
   SEAINT-SEAOSC-list-owner(--nospam--at)mail-list.com.

Sponsored By: Pacific Structural & Forensic Engineers Group, Inc. (PSFEG)

To unsubscribe, switch to/from digest, get on/off vacation, or change your email address, click here.
<http://cgi.mail-list.com/u?ln=seaint-seaosc&nm=seaintma%40euken.net>