Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: Painting/Coating Structural Steel Exposed tothe Elements

[Subject Prev][Subject Next][Thread Prev][Thread Next]
David,

Thank you, David. It was Bill Allen who was looking for this and I'm sure he has seen your posting.

Regards,

Daryl

----- Original Message ----- From: "David Cohen (Baran Raviv)" <dcohen(--nospam--at)barviv.co.il>
To: <seaint-seaosc(--nospam--at)mail-list.com>
Sent: Monday, July 29, 2013 12:13 AM
Subject: RE: [SEAINT-SEAOSC] Painting/Coating Structural Steel Exposed tothe Elements

Hi Daryl
I can suggest to follow this procedure in order to paint above HDG steel
elements: Galvanized Material Paint Preparation System
1 The following system shall be used to coat all surfaces, other than bar
grating, which have been previously hot dipped galvanized; including, but
not limited to handrails, handrail sockets, ladders, stairways, cages, toe plates, guard rails, clips, heliport safety panels, etc.
2 Surface Preparation
Surfaces must be clean and dry. Remove any and all oil, grease and other
contaminates with a non-residual leaving hydrocarbon cleaner/remover such
as Carboline #3 or equal from the surfaces to be coated prior to any
blasting and/or coating.
NOTE: It is important to remove any and all evidence of the oily film
residue that is on the surfaces of any galvanized steel.
SSPC-SP7 brush off blast finish (NACE No. 4) the surface of the galvanized steel to obtain a 1.0 mil anchor profile. 3 Prime Coat: Epoxy Primer - 3.0 to 5.0 mils D.F.T. Minimum solids content to be 70% by volume.
4 Finish Coat: Unmodified Aliphatic Acrylic Polyurethane Epoxy – 1.5 to
2.0 mils D.F.T. Minimum solids content to be 65% by volume.

Truncated 1217 characters in the previous message to save energy.

-------------------------------------------------------------------------
Post your message to the list by sending it to: SEAINT-SEAOSC(--nospam--at)mail-list.com.

The email messages sent to the list will be saved in an archive on the World Wide Web.
These archives are located at:
   http://archive.mail-list.com/SEAINT-SEAOSC

To contact the list owner, send your message to:
  SEAINT-SEAOSC-list-owner(--nospam--at)mail-list.com.

Sponsored By: Pacific Structural & Forensic Engineers Group, Inc. (PSFEG)

To unsubscribe, switch to/from digest, get on/off vacation, or change your email address, click here.
<http://cgi.mail-list.com/u?ln=seaint-seaosc&nm=seaintma%40euken.net>