Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: ole plate nailing for 1 1/8 plywood floor sheathing

[Subject Prev][Subject Next][Thread Prev][Thread Next]
Greetings,

is there any affordable software for form work design available?

On Thu, Aug 8, 2013 at 9:06 PM, Chuck Utzman <chuckutzman(--nospam--at)gmail.com> wrote:

> I always use SDS lags regardless of the ply. thickness. The framers can't
> tell if they hit the rim/block otherwise.
> Chuck Utzman, P.E.
> 
> 
> On 8/8/2013 12:59 PM, NW27 wrote:
> 
>> Hi
>> Is possible to use 16d nails for sole plate nailing when 1 1/8 plywood
>> sheathing is used even if the spacing very small
>> or it has to to be long nail 20d or 30d or lag screws?
>> thanks for replying
>> 
>> thanks
>> nw
>> 
> 
> ------------------------------**------------------------------**
> -------------
> Post your message to the list by sending it to:

Truncated 391 characters in the previous message to save energy.

<http://cgi.mail-list.com/u?**ln=seaint-seaosc&nm=**wafordavid%40gmail.com>

-------------------------------------------------------------------------
Post your message to the list by sending it to: 
   SEAINT-SEAOSC(--nospam--at)mail-list.com.

The email messages sent to the list will be saved in an archive on the World Wide Web.
These archives are located at:
    http://archive.mail-list.com/SEAINT-SEAOSC

To contact the list owner, send your message to:
   SEAINT-SEAOSC-list-owner(--nospam--at)mail-list.com.

Sponsored By: Pacific Structural & Forensic Engineers Group, Inc. (PSFEG)

To unsubscribe, switch to/from digest, get on/off vacation, or change your email address, click here.
<http://cgi.mail-list.com/u?ln=seaint-seaosc&nm=seaintma%40euken.net>