Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

HSS thin gage section properties

[Subject Prev][Subject Next][Thread Prev][Thread Next]
I need the section properties (A,S and I) for thin walled HSS shapes. The AISC shapes go down to 1/8" and I need the properties for 12 and 14 gage wall thicknesses. I haven't found anything in North America, came across some European manufacturers who do thin walled down to 2.5 mm.

Drew Morris, PE*| Project Engineer
BBFM Engineers, Inc. <>
510 L Street, Suite 200 | Anchorage, Alaska 99501
Ph: (907)274-2236 | Direct: (907)270-2240 | Web:

Post your message to the list by sending it to: SEAINT-SEAOSC(--nospam--at)

The email messages sent to the list will be saved in an archive on the World Wide Web.
These archives are located at:

To contact the list owner, send your message to:

Sponsored By: Pacific Structural & Forensic Engineers Group, Inc. (PSFEG)

To unsubscribe, switch to/from digest, get on/off vacation, or change your email address, click here.