Need a book? Engineering books recommendations...

Return to index: [Subject] [Thread] [Date] [Author]

Re: HSS thin gage section properties

[Subject Prev][Subject Next][Thread Prev][Thread Next]
Welding of sheet (3/16" thick or less) steel is covered in "AWS D1.3 
Structural Welding Code - Sheet Steel" You can download the general 
provisions chapter here: and the 
 table of contents is available here:

Oshin Tosounian, S.E.

 From: "T. William (Bill) Allen, S.E." <bill(--nospam--at)ALLENDESIGNS.COM>
To: seaint-seaosc(--nospam--at)
Sent: Tuesday, February 11, 2014 8:06 AM
Subject: RE: [SEAINT-SEAOSC] HSS thin gage section properties

...and AISI permits welds thicker than the thinnest part joined?

T. William (Bill) Allen, S.E. (CA 2607)
A L L E N   D E S I G N S
Consulting Structural Engineers
33171 Paseo Cerveza, Suite 221
San Juan Capistrano, CA 92675
V (949) 248-8588 • C (949) 374-1536

-----Original Message-----
From: seaint-seaosc(--nospam--at) [mailto:seaint-seaosc(--nospam--at)] On
Behalf Of nma Sent: Tuesday, February 11, 2014 7:53 AM
To: seaint-seaosc(--nospam--at)
Subject: Re: [SEAINT-SEAOSC] HSS thin gage section properties

I think that the welding requirements would be from AISI not AISC.


Truncated 604 characters in the previous message to save energy.

Post your message to the list by sending it to: 

The email messages sent to the list will be saved in an archive on the World Wide Web.
These archives are located at:

To contact the list owner, send your message to:

Sponsored By: Pacific Structural & Forensic Engineers Group, Inc. (PSFEG)

To unsubscribe, switch to/from digest, get on/off vacation, or change your email address, click here.